Deploying to carrier in scenario.

[Indie95]

I'm Probably being a numpty but I can't figure out how to deploy to a carrier in scenario creation, Any pointers would be appreciated.

Cheers.

[lvjtn]

there are two ways to do it (using the the same tool from different menus)

a) map settings view

1. open the scenario, switch to “map settings view”
2. select the unit what you want to put in a carrier or hangar
3. rigth click on the selected unit
4. select the “status” tab
5. select the “start in” drop-down menu, and if there is at least one hangar / container with matching hangar / container weight, you can choose it



b) unit settings view

1. open the scenario, switch to “unit settings view”
2. select the “status” tab
3. select the “start in” drop-down menu, and if there is at least one hangar / container with matching hangar / container weight, you can choose it



c) checking the carrier / hangar whether everything is fine

1. inspect the carrier / hangar on the map or in the unit list
2. select the “status” tab
3. you should see “hangars: x/y” where x means the number of the embarked units, y means the total number of the hangar / carrier slot(s)
4. click on the “view” button, and you should see the unit what you put in the carrier / hangar previously



(i'm adding this as a new faq entry)